Don't forget the small thrust washer that goes under the left hand part otherwise the gear lever will not engage correctly.The Oil seal for the gear change drive spline through the case can be changed with the engine in place from the outside.
Correct Gear Change Linkage
Forum rules
To use Search function add Asterisks around the words like *fork oil*
No Racism.Slanging Matches(unless witty and funny
No spamming.Anonymous posting disabled.
To use Search function add Asterisks around the words like *fork oil*
No Racism.Slanging Matches(unless witty and funny
No spamming.Anonymous posting disabled.
1 post
• Page 1 of 1
Correct Gear Change Linkage
by Gman » Fri Aug 22, 2008 10:28 pm
This is how the teeth should mesh correctly before re-fitting the Rear case on a Cx/GL500,
Don't forget the small thrust washer that goes under the left hand part otherwise the gear lever will not engage correctly.The Oil seal for the gear change drive spline through the case can be changed with the engine in place from the outside.
Don't forget the small thrust washer that goes under the left hand part otherwise the gear lever will not engage correctly.The Oil seal for the gear change drive spline through the case can be changed with the engine in place from the outside.
-
Gman - Site Admin
- Posts: 1089
- Joined: Thu Jul 24, 2008 8:11 pm
- Location: Hull.Yorkshire.UK.2x1980 CX500ZABs:Citroen ZX TD(250,000 miles)
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests
This free, ad-free forum is hosted by ForumLaunch
